ijier logo

Tribological test of compressor used in the refrigeration industry

Authors
DOI:
https://doi.org/10.31686/ijier.vol8.iss11.2729
Keywords:
Array, Array, Array
Abstract

The article describes the analytical procedures and acceptance criteria for analysis of compressor and components with a focus to tribological aspects. In the introduction, the article deals with tribology as a scientific discipline. Subsequently, the article describes different kinds of wear, which may occur during the operation of compressor at different levels. Subsequently, the article mentions the equipment used in the test. At the end the results of the test are summarized with complete photo-documentation.

Author Biographies
  1. Lubica Bednarova, Technical University of Košice

    Department of Power Engineering, Faculty of Mechanical Engineering

  2. Lukáš Tóth, Technical University of Košice

    Department of Power Engineering, Faculty of Mechanical Engineering

  3. Filip Duda, Technical University of Košice

    Department of Power Engineering, Faculty of Mechanical Engineering

  4. Ľubomíra Kmeťová, Technical University of Košice

    Department of Power Engineering, Faculty of Mechanical Engineering

References

An important anniversary of tribology and tribotechnics in Slovakia [online], cit. [2020-09-14], online in: <https://www.engineering.sk/clanky2/tribologia-a-tribotechnika/3793-vyznamne-vyrocie-tribologie-a-tribotechniky-na-slovensku>

DZIMKO, M. : Úlohy a význam tribológie v technických systémoch, Workshop Žilina, 25.

Kvalifikácia opotrebenia podľa STN 01 5050 [online], 2010, cit: [2020-09-14], Online in: <http://www.kvalitaprodukcie.info/12-klasifikacia-opotrebenia-podla-stn-01-5050/comment-page-1/>

Downloads
Published
2020-11-01
Issue
Vol. 8 No. 11 (2020): International Journal for Innovation Education and Research
Section
Journal Articles
License

Copyright (c) 2020 Lubica Bednarova

Creative Commons License

This work is licensed under a Creative Commons Attribution-NoDerivatives 4.0 International License.

Copyrights for articles published in IJIER journals are retained by the authors, with first publication rights granted to the journal. The journal/publisher is not responsible for subsequent uses of the work. It is the author's responsibility to bring an infringement action if so desired by the author for more visit Copyright & License.

How to Cite

Bednarova, L., Tóth, L. ., Duda, F. ., & Kmeťová, Ľubomíra. (2020). Tribological test of compressor used in the refrigeration industry. International Journal for Innovation Education and Research, 8(11), 412-419. https://doi.org/10.31686/ijier.vol8.iss11.2729